Kenton Jupiter-4 (before Dec 05) User Manual download pdf

KENTON

electronics

INSTRUCTIONS FOR MIDI INTERFACE

ROLAND JUPITER 4

USING THE MIDI INTERFACE

When you turn on the synthesizer for the first time, you will be in omni-on mode for receive (all channels) - See

next page for factory default settings When you select a receive channel, it will be stored in memory and will be

remembered for when you subsequently turn on the synth - all parameters listed on the next page are stored.

If you want to put the machine back to the factory default settings at any time, switch the synth on whilst holding

the red push button pressed - hold for a couple of seconds then release.

RED PUSH BUTTON

Two modes are available by pushing the red push button. Before you press the red button however, make sure

that no notes are pressed on the synth otherwise the results may be unpredictable.

1) SET-UP MODE

Setting MIDI channels and assignments. Give the red push button two short presses (half a second each) - then

release. Follow this with a note or sequence of notes as detailed on page 2. After selecting a channel you will be

automatically returned to playing mode but after making assignments you will need to press the ENTER key (Top

C) to return to playing mode. This is to enable you to make the multiple key presses required when re-assigning

sources to destinations. (N.B. set-ups are stored in non volatile memory).

2) TRANSPOSE MODE

Press and hold the red push button for four seconds - then release. Middle C will sound on the synth and

continue to sound until you press a key. The note that you press will be the new middle C for MIDI IN. You can set

any value up to two octaves up or down. Settings outside this range will be ignored. Note that transpose mode

cannot be entered from program mode.

ASSIGNING MIDI CONTROL SOURCES TO DESTINATIONS

SOURCES DESTINATIONS (d)=factory default

AFTERTOUCH off / modulation (d)/ p.bend / vcf / not used

CONTROLLER X off / vcf (d) / not used

CONTROLLER Y off / vcf / not used (d)

VELOCITY off (d) / vcf / vca

MIDI VOLUME off / vca (d)

Sources can control more than one destination at once, but a destination can only be controlled by one source at

a time. Thus if velocity is currently controlling VCF and then you switch aftertouch to VCF, velocity will then control

nothing until re-assigned.

1 2 3 4

ROLAND JUPITER 4 1

Summary of Contents

Page 1 - ROLAND JUPITER 4

KENTONelectronicsINSTRUCTIONS FOR MIDI INTERFACEROLAND JUPITER 4USING THE MIDI INTERFACEWhen you turn on the synthesizer for the first time, you will

Page 2

C Receive channel 1 [ Bottom C ] MIDI note number 36Db " " 2D " " 3Eb " " 4E" " 5F " " 6Gb &q

Page 3

1) Controller X can be any MIDI controller. After pressing the red push button twice to enter SET-UP mode,operate the required MIDI controller before

Page 4

MIDI CONTROL OF RED PUSH BUTTONThe red push button can be "pressed" via MIDI as MIDI switch number 95 (5Fh) for regular program mode or 94(5

Comments to this Manuals

No comments

Kenton Jupiter-4 (before Dec 05) User Manual

Browse online or download User Manual for Equipment Kenton Jupiter-4 (before Dec 05). Kenton Jupiter-4 (before Dec 05) User Manual [pl] [cs] [en] [de]

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Kenton Jupiter-4 (before Dec 05)