KENTONelectronicsGS-2MIDI Guitar Amplifier Foot-Switch ControllerUser Instructions
IntroductionAt last, an affordable unit which enables you to put your amplifier foot-switches(channel/overdrive/graphic etc.) under MIDI control, enab
1, Channel and System SettingsTo be in Channel edit mode, the yellow `CHannel` LED must be lit. If the `PATch` LED is lit, pressthe `PATCH/CHAN` key.T
2, Patch Edit ModeSelecting patches;To be in patch edit mode, the green `PATch` LED must be lit. If the `CH` LED is lit, press the`PATCH/CHAN` key.The
3, Controller Assignment ModeThis is an `advanced` programming mode is for those who wish to control each of the amplifierfoot-switches individually (
GS-2 System Exclusive InformationThe first five bytes are always the same for all data types;[ 1] F0h - Sysex command[ 2] 00h - Company identity first
ddd = 011 = memory dump[ 7] 000000bb - where bb = memory area as per info request[ 8] 00yyyyy - where yyyyy = number of bytes[ 9] 0000xxxx - where xxx
Controller NumbersController Number Control FunctionDecimal Hex0 00H Bank switch MSB1 01H Modulation wheel/lever2 02H Breath controller3 03H U
SpecificationsPower; 240V, 50HzNote; The GS-2 has a built in mains transformer factory set to 240 volts AC 50Hz unless otherwisemarked. The transforme
Comments to this Manuals